icon flashes
Is the handset registered correctly to the base, see page 38.
•
Check that the mains power is correctly connected.
•
Check that the handset is within range of the base.
•
The batteries are low, place the handset on the base/charger to recharge.
•
You hear the busy tone when you press
Make sure the handset is in range of the base.
•
Another handset registered to your BT Graphite 3500 base may be on the line.
•
Answering machine does not record any messages
The memory may be full. Play and delete old messages, see pages 31 and 34.
•
The answering machine might be switched off or set to Answer only. See pages 30 or 32.
•
Answering machine messages have the wrong date and time
Have you set the date and time? See page 8.
•
Cannot access your messages from another phone
Have you changed the master PIN code? See page 39. Always keep a note of the new PIN code in
•
a safe place. Reset the PIN, page 39.
No Caller Display number/name displayed
Have you subscribed to a Caller Display service from your network provider, see page 24.
•
The caller may have withheld their number.
•
An exact name/number match was not found in your directory. Check that you have stored the
•
full STD dialling code.
Cannot register a handset to a base
You can register a total of up to 5 handsets to your BT Graphite 3500 base. Check that you have
•
not exceeded the limit.
Check that you have entered the correct PIN number (default PIN 0000).
•
Check that you are at least one metre away from other electrical equipment to avoid interference
•
when registering.
If you experience any problems, please call the Helpline on Freephone 0808 100 6556* or visit www.bt.com/producthelp
9881 Graphite 3500 UG [1].indd 41
.
41
13/9/10 16:30:31