To inflate using any Sevylor
1. To begin inflation, open external cap and pull
firmly on the lanyard to extend out. This will
open internal yellow seal.
3. When fully inflated, seal valve by pushing in
with pump nozzle. This will seal the internal
yellow stopper and keep air from escaping
while closing cap. Gently twist adapter sleeve
to right while backing pump out of valve.
To inflate using the Sevylor
inflation device:
1. To begin inflation, open external cap and pull
firmly on the lanyard to extend out. This will
open internal yellow seal.
3. When fully inflated, seal valve by pushing in
with pump nozzle. This will seal the internal
yellow stopper and keep air from escaping
while closing cap. Gently twist adapter sleeve
to right while backing pump out of valve.
INFLATION INSTRUCTIONS
QuickPump™ unit:
®
Dual Action Hand Pump or other
®
2. Attach adapter nozzle to inflation end of
pump. Insert pump and turn on.
Note: The pump may look different from
yours. It is for illustration purposes only.
4. Fully remove pump and close external
cap. Valve should appear depressed
into itself.
2. Attach adapter nozzle to inflation end of
pump. Insert pump and turn on or
start pumping.
Note: The pump may look different from
yours. It is for illustration purposes only.
4. Fully remove adapter and close external
stopper. Valve should appear depressed
into itself.
3