Liftaway LA-SDO1 Instruction Manual page 15

4. Auto-close setting
5. Photo beam setting (optional accessory)
6. O/S/C Terminal
Press 'UP' button and hold on until the LED displays '-'. Press
'up' button once, the auto-close time will increase 1 minute,
the maximum time is 9 minutes. Press 'down' button the auto-
close time decrease 1 minute. The auto-close function will be
turned off when LED displays 0. Press 'SET' button to
confirm.
Press 'DOWN' button and hold on until the LED displays'11',
press 'UP' button the LED displays 'H', photo beam function is
available. Press 'DOWN' button the LED displays '11' to
cancel this function. When setting is finished, press 'SET' to
confirm. When connecting pulsed quantity control infrared
sensor, wire as per Fig. 9. When infrared sensor is controlled
by which value, wiring as Fig. 10. Notice: Close the photo
beam function when not utilising the photo beam sensor.
Connecting a touch off switch to this terminal, you can
use the switch when maintaining or the transmitter is left in
garage.
15