Liftaway LA-SDO1 Instruction Manual page 11

1. As Fig.5, slide the end rail into the 1st sleeve, slide the middle rail into the 1st sleeve;
2. As Fig.6, slide the 2nd sleeve to the other end of middle rail, slide the top rail into the 2nd sleeve;
3. Remove the plastic film on the end rail, cut the plastic cable tie on the screw rod "A";
4. As Fig.7, pull the screw rod "A" along with inner chain to the end of top rail ;
5. As Fig.8, undo the nut & spring;
6. Tight the nut to the right position as shown in Fig.9, cut the plastic cable tie on sprocket. Rail is now
assembled.
Installation
1. Fix the track bracket to the wall 2cm-15cm over the shaft or intermediate bracket (depending on the
actual installation space).
Fig. 8
11