Table of Contents
Advertisement
Note:
other printers may not work with your
new printer.
28
Install memory and option cards
Installing a
firmware card
Firmware cards designed for
4
Align the notches on the bottom of
the card with the notches on the
connector.
5
Push the memory card firmly into
the connector until the latches on
either end of the connector snap
into place.
It may require some force to fully
seat the card.
6
Make sure each latch fits over the
notch on the end of the card.
Follow the instructions in this section to
install a firmware card.
If you have a network internet model, an
ImageQuick™ firmware card is already
installed.
If an option card has been installed, you
need to remove the option card before
installing the firmware card.
1
Remove the system board access
cover (see page 24).
Advertisement
Table of Contents
