Table of Contents
Advertisement
Step 4
Completing the housing installation
Pull cable from headend thru the mount gimbal mount. Connect BNC connectors and mark
power connection to the camera.
Note: Polarities must be observed the camera is 12V DC and damage will result if power
polarities are not observed. Power connector has a positive center pin.
Mount the housing to the gimbal using the M6 Allen head screws at the top and bottom.
Place the external tooth washer between the housing and the gimbal mount then the split
lock washer on the M6 screw and insert the screw into the housing through the gimbal
mount and external tooth lock wasker. Install the bolt and washers assembly at the bottom
and top of the gimbal mount finger tight.
Adjust the camera housing right or left to acquire the proper field of view for the installation.
M6 Allen head screw
Split lock washer between gimbal mount and housing
External tooth lock washer under head of bolt
* Camera lens position can be adjusted up and down 5 degrees
o
92
Interface Cable for power and video connection to head end cable.
o
92
o
92
o
5
8
o
5
Advertisement
Table of Contents
