Lexmark OptraTM Service Manual page 57

4026-0XX
Wrinkled Paper/Envelope/Transparency
FRU
1 Paper
2 Paper Path
Paper Never Leaves The Tray or Fails To Reach The Input Sensor
Note: Remove the Optional Second Paper Tray if installed before
performing the following checks.
FRU
1 Paper
2 Paper Take-
Up Solenoid
3 Paper Frame
Assembly
4 D-Roll
Assembly
5 Paper Lift
Plate Assem-
bly
6 Print Media
Selection
Lever
(Models 06C
and 06F)
Action
Check the paper supply for wrinkled or damaged
paper, out of specification paper, envelopes or
transparency material. Correct as necessary.
Check the paper feed lift plate assembly, input
sensor actuator, paper separators, paper feed
rollers or anything in the paper path that might
catch the paper or cause the paper to wrinkle.
Action
Check the paper supply for any paper, envelope,
transparency, label, or index cards that may be
causing a problem.
Be sure the paper take-up solenoid is picking. If
incorrect go to the
Service Check" on page
Check the paper feed frame assembly for proper
operation. If incorrect go to the
Frame Assembly Service Check" on page
Check the D-Roll assembly for proper operation.
If incorrect go to the
Check" on page 2-16
Check the paper lift plate assembly for proper
operation. If incorrect, replace the paper lift plate
assembly.
Check the print media selection lever on models
06C and 06F for the correct setting. This is
determined by the media being used ( labels,
card stock, paper, etc. ).
"Paper Take-Up Solenoid
2-32.
"Paper Feed
"D-Roll Assembly Service
Diagnostic Information 2-35
2-37.