TG6511-6521HG(e-hg).book Page 46 Friday, January 22, 2010 2:49 PM
Useful Information
Problem
I cannot register a handset to a
base unit.
*1 KX-TG6521
Battery recharge
Problem
The handset beeps and/or )
flashes.
I fully charged the batteries, but
– ) still flashes or
– the operating time seems to be
shorter.
The handset display is blank.
Making/answering calls, intercom
Problem
_ is displayed.
Noise is heard, sound cuts in and
out.
46
Cause/solution
L The maximum number of handsets (6) is already
registered to the base unit. Cancel unused handset
registrations from the base unit (28. oldal).
L You entered the wrong PIN. If you forget your PIN,
contact an authorised service centre.
Cause/solution
L Battery charge is low. Fully charge the batteries (8.
oldal).
L Clean the battery ends (S, T) and the charge
contacts with a dry cloth and charge again.
L It is time to replace the batteries (8. oldal).
L The handset is not turned on. Turn the power on
(12. oldal).
Cause/solution
L The handset is too far from the base unit. Move
closer.
L The base unit's AC adaptor is not properly
connected. Reconnect AC adaptor to the base unit.
L The handset is not registered to the base unit.
Register it (27. oldal).
L Activating one touch eco mode reduces the range
of the base unit in standby mode. If required, turn
eco mode off (13. oldal).
L You are using the handset or base unit in an area
with high electrical interference. Re-position the
base unit and use the handset away from sources
of interference.
L Move closer to the base unit.
L If you use a DSL/ADSL service, we recommend
connecting a DSL/ADSL filter between the base
unit and the telephone line jack. Contact your
DSL/ADSL provider for details.
L Unplug the base unit's AC adaptor to reset the unit
and turn off the handset. Reconnect the adaptor,
turn on the handset and try again.