Replacing Batteries; Technical Specifications Pro-Ject Pre Box Rs; Service; Warranty - Box-Design Pro-Ject Pre Box RS Instructions For Use

Replacing batteries

Proceed as follows:

Unlock and slide open the battery case cover

Replace the battery.
Make sure the battery is the right way round !

Close the battery case cover
Battery type: 1 x CR2032 / 3V or 1 x CR2025 / 3V
Do not dispose the batteries as ordinary domestic refuse. Please dispose your exhausted batteries at
the appropriate collection sites - usually located at supermarkets and drugstores.

Technical specifications Pro-Ject Pre Box RS

Tubes:
Frequency response:
Noise floor:
THD:
Gain XLR and RCA outputs *:
Pre out (Pre Out):
Record Out (Out):
gain ratio input / output signal.
Fixed output signal
Line-level inputs:
Input impedance:
Wiring XLR sockets:
Outboard power supply:
Power consumption:
Replacement battery remote control:
Dimensions W x H x D (D with sockets): 206 x 72 x 200 (210)mm
Weight:

Service

Should you encounter a problem which you are not able to alleviate or identify, please contact your dealer for
further advice. Only when the problem cannot be resolved there should the unit be sent to the responsible
distributor in your country.

Warranty

The manufacturer accepts no responsibility for damage caused by not adhering to these instructions
for use. Modification or change to any part of the product by unauthorized persons release the
manufacturer from any liability over and above the lawful rights of the customer.

Copyright

PRO-JECT is a Registered Trademark of H. Lichtenegger.
This guide was produced by: Audio Trade GmbH
Copyright © 2014. All rights reserved.
4
© Audio Trade GmbH · Pro-Ject Pre Box RS (from S/N D16273) · Revision 2014.2.1
2 x ECC88 (6922)
20Hz - 50kHz (0dB/-0,8dB)
95dB (A weighted)
0,06%
XLR 12dB / RCA 6dB for input In 1 and input In 4
XLR 6dB / RCA 0dB for inputs In 2 & In 3 and inputs In 5 & In 6
1 pair XLR sockets (balanced connection).
* Unbalanced connection via supplied connection cable (XLR  RCA)
RCA input In 1, gain -6dB
RCA inputs In 2 & In 3, gain 0dB
XLR input In 4, gain -6dB
XLR inputs In 5 & In 6, gain 0dB
3 pair RCA/phono sockets and 3 pair XLR sockets
150kohms for RCA input In 1 and XLR input In 4
30kohms for RCA inputs In 2 & In 3 and XLR inputs In 5 & In 6
1 ground, 2 "hot" and 3 "cold"
20V/3A DC, suitable for your country's mains supply
700mA DC, <1W in standby
1 x CR2032 / 3V or 1 x CR2025 / 3V
1950g without power supply
The information was correct at the time of going to
press. The manufacturer reserves the right to make
changes to the technical specification without prior
notice as deemed necessary to uphold the ongoing
process of technical development.