Mains Power Connection; Remote Control; Front Panel Controls; Input Selector - Box-Design Pro-Ject Pre Box RS Instructions For Use

Mains power connection

Connect the low voltage plug from the power supply to the Power 18-20V
power supply to the mains.

Remote control

ON/OFF
CH+
VOL+
VOL-
CH-

Front panel controls

Pre Box RS
To switch on from standby or to standby
The switch on the left hand side of the front panel turns the unit on or back into standby. The blue LED above
the stand-by switch shows that the unit is switched on.
After switching on, the tubes need a short time to reach the correct operating temperature. During
warm up the blue LED above the stand-by switch is blinking.
We recommend to set the volume control to 0, prior to switching on.

Input selector

After the unit is powered on, operating the switch next to the six LEDs selects the inputs. The selected input
will be shown by the corresponding LED.

Volume

Adjust the volume to the desired level, using the large knob on the front panel.
1
ON/OFF
turns the unit on or back into standby
0
0 _
VOL
VOL
and
0
0 _
CH
CH
and
© Audio Trade GmbH · Pro-Ject Pre Box RS (from S/N D16273) · Revision 2014.2.1
+
adjust the sound volume
+
select the inputs
" socket before connecting the
3