Front Panel Controls; Replacing Batteries - Box-Design Pro-Ject Stereo Box S2 Instructions For Use

Table of Contents

Front panel controls

To switch on from standby or to standby

The push button on the left hand side will toggle the phono amplifier between its fully operational status and

standby. The blue LED above the stand-by push button shows that the unit is switched on.

Input selector

Press the push button next to the 3 LEDs to switch between the inputs. Selected input number will be

illuminated.

Volume

Adjust the volume to the desired level, using the large knob on the front panel.

Remote control

Proceed as follows:

•

Unlock and slide open the battery case cover

•

Replace the battery.

Make sure the battery is the right way round !

•

Close the battery case cover

Battery type: 1 x CR2032 / 3V or 1 x CR2025 / 3V

Do not dispose the batteries as ordinary domestic refuse. Please dispose your exhausted batteries at

the appropriate collection sites - usually located at supermarkets and drugstores.

turns the unit on or back into standby (long press), mute (short)

and

adjust the sound volume

and

select the inputs

Table of Contents

Do you have a question about the Pro-Ject Stereo Box S2 and is the answer not in the manual?

S2 bt