Basic Features; Making An Outgoing Call - Iwatsu ADIX APS Omega-Phone Digital Multiline series Quick Reference Manual

INTRODUCTION
This guide describes basic features and operations
for ADIX APS Omega-Phone telephones. This includes
Omega-Phone Digital Multiline Telephones and the
Omega-Phone MKT Versa-Phone.
Certain features are not available on all ADIX models.
For more information, refer to the ADIX Owner's
Manual or contact your authorized Iwatsu
distributor.
Multipurpose Buttons - These buttons can be
programmed for specific functions, including outside
line access, individual extension selection, and one-
touch feature operation.
Button Lamps - These lamps light up or flash when
someone is using the line or feature corresponding to
that button. A green lamp indicates that you are using
that line/feature. A red lamp indicates that someone
else is using that line/feature.
SPKR (Speaker) - This button allows you to dial and
receive outside or internal calls and converse without
lifting the receiver while using the hands-free operation
feature.
TRAN (Transfer) - This button allows you to transfer a
call from your phone to another extension.
FEAT (Feature) - This button is used to access many
ADIX features.
HOLD/DND (Hold/Do Not Disturb) - This button is
used to put a call on Hold or to set the Do Not
Disturb function to prevent any calls from getting
through or ringing at your extension.
Handset/Speaker Volume Control - The handset/
speaker volume control buttons allow you to adjust
the handset volume and speaker volume to one of
three levels. The left button lowers the handset/
speaker volume and the right button raises the
handset/speaker volume.
Ringer Volume Control - The ringer volume control
button allows you to adjust the ringer volume to one
of four levels.
MIC OFF - Press the [MIC OFF] button to toggle the
microphone off and on. When the [MIC OFF] button
is lit the microphone is off. When the [MIC OFF]
button is not lit, the microphone is on. Turning the
microphone off prevents the person on the other end
of your call from hearing voice or sounds during a
speakerphone or ICM hands-free answerback call.
ICM - The intercom system is the internal network
used to communicate between the telephone
extensions in your ADIX system. Pressing the [ICM]
button connects you to an intercom line for
conversation with other extensions.

BASIC FEATURES

Making an Outgoing Call

Lift the receiver
Press an outside line button. You will hear a dial
tone.
Dial telephone number
Make a dialing mistake?
Press the [FLASH] button to get new dial tone
Dial again
Receiving an Incoming Call
When your phone rings and lamp flashes
Lift the receiver to connect the call
If your phone does not connect you to the call
automatically
When your phone rings and lamp flashes
Lift the receiver
Press the button with the flashing lamp to connect
the call