Table of Contents
Advertisement
OPERATING HEATER
Continued
MANUAL LIGHTING
PROCEDURE
1. Follow steps 1 through 5 under Lighting
Instructions, page 21.
2. Press control knob and light pilot with
match.
3. Keep control knob pressed in for 30 seconds
after lighting pilot. After 30 seconds, release
control knob. Now follow step 8 under
Lighting Instructions, page 22.
OPTIONAL HAND-HELD
REMOTE OPERATION
Note: All remote control accessories must be
purchased separately (see Accessories, page
34). Follow instructions included with the
remote control.
NOTICE: You must light the pilot
before using the hand-held re-
mote control unit. See Lighting
Instructions on page 19.
After lighting, let pilot flame burn for about
one minute. Turn control knob to ON posi-
tion. Adjust flame adjustment knob anywhere
between HI and LO. Slide the selector switch
to the REMOTE position (see Figure 30).
Note: The burner may light if hand-held
remote was on when selector switch was last
turned off. You can now turn the burner on and
off with the hand-held remote control unit.
IMPORTANT: Do not leave the selector switch
in the REMOTE or ON position when the pilot
is not lit. This will drain the battery.
Flame Adjustment Knob
Selector Switch in Remote Position
(Optional Remote Control)
Figure 30 - Setting the Selector Switch,
Control Knob, and Flame Adjustment
Knob for Hand-Held Remote Operation
Available from Allparts Equipment and Accessories - 1-877-475-5660 - www.allpartsinc.com
Control Knob
in On Position
ON
OFF
REMOTE
ON/OFF SERIES (MODEL HRC100)
Hold the control button on the hand-held
remote until burner turns on. Hold the con-
trol button again until burner turns off (see
Figure 31).
To Lock press both buttons on hand-held
remote control until light stops flashing. Hand-
held remote control is now locked. If the fire is
on it will be turned off automatically. In the
locked state, the light will not light up when
any button is pressed.
To Unlock press both buttons together on hand-
held remote control until the light stops flashing.
The hand-held remote is now unlocked.
Indicator
Light
Figure 31 - On/Off Hand-Held Remote
Control Unit (HRC100)
THERMOSTAT SERIES (MODEL
HRC200)
The hand-held remote can be operated using
either the manual mode (MANU) or thermo-
static mode (AUTO) (see Figure 32). To select
Fahrenheit/Centigrade mode display, carefully
press the ˚C/˚F mode button with the end of a
paper clip or similar blunt object.
Digital Display
Shows
Temperature
and Settings
Locks
System to
LOCK
Prevent
Accidental
Ignition
MANU
Turns
Burners
On or Off
Increases or Decreases Room
Temperature in AUTO Mode
Figure 32 - Thermostat Hand-Held
Remote Control Unit (HRC200)
Control
Button
Hand-Held
Remote On
AUTO
or Off and
ROOM
SET
TEMP
TEMP
Allows You
to Choose
TEMP
POWER
the Manual
AUTO
ºC/ºF
Selects
AUTO
Mode
°C/°F Mode
Button
Turns
Setting
Advertisement
Table of Contents
