System Setting (Arming) - jablotron Oasis User Manual

The service code
The service code is a special code designed for a service company. The code
allows maintenance technicians system configuration and testing.
Note: it can be set by a service technician that by means of a service code it is
possible to unset the system to provide full service and maintenance of the system
under any circumstances (he will not be able to modify or add user codes).
Unsetting the system by the service code can only be enabled with the written
agreement of the owner of the system – see  15.

1. System setting (arming)

There are several ways to set (arm) the system.
An unsplit system (
•
Enter a code (present a card).
•
On the key-fob, press the
•
If operation without an access code is enabled (
(arm) the system by pressing the ABC key.
A system with partial setting (arming) (
•
If operation without an access code is enabled (
to press the A button to set section A, the B button to set both
sections A and B, or the ABC button to set the entire system.
•
When the system is only partially set (e.g. only section A), it is
possible to extend the proportion of the system armed by pressing
the corresponding button (B or ABC). All detectors configured to
delayed or next-delayed reactions will provide an exit delay. Thus,
you will not need to turn off partial setting first to set the whole
system each time you leave the house. Instead, you can perform total
setting straight away and the system allows departure through all
zones covered by delayed and next delayed detectors.
•
If operation without an access code is disabled (
the A, B, or ABC key must always be followed by entering an access
code (or by presenting an access card).
•
Key-fob:
Oasis user manual
1.)

button.
press for total setting (A + B + C)
press to set section A
press to set sections A+B
4
4.), you can set

2.)

4.), you only have

4.), then pressing

MKE22102