Remote Control - By Phone, Internet; User Configuration - Access Codes (Cards) - jablotron Oasis User Manual

Device X (
Device Y (
The outputs may be used to unlock locks – opening a door via a short impulse).
In this case, enter the following:
an impulse to operate (
an impulse to operate (
Optionally, the system can be pre-programmed by a service company so that
the above operations require an access code (card).
9. Remote control – by phone, Internet
If the control panel is equipped with a suitable communicator (
control it remotely by mobile phone (directly by using the phone's keypad or
by SMS). It can be also controlled via the Internet – after registration on
www.GSMLink.cz
User configuration – access codes (cards)
The following description is intended for a system administrator, who knows
the control panel master code or possesses a master card which is authorized to
modify the system configuration.
All the settings can be performed via keying-in on a system keypad (or very
comfortably via a PC running Olink software). An unfinished sequence can be
cancelled by pressing the # key. A sequence is stored into control panel
memory only after the sequence has been completely entered.
Note: The Oasis JA-80 system has three modes: operating mode,
maintenance mode and service mode. Operating mode is for the day-to-day
use of the system by all authorized users,
(arming/disarming). Maintenance mode is for the holder of the master code
(system administrator) to have limited programming of the system, e.g.
changing codes/cards, bypassing and is inaccessible to all other users. Service
mode is only for installers and is used to program and control all aspects of the
system.
Oasis user manual
13.) turn ON

turn OFF
14.) turn ON

turn OFF
13.) is provided by pressing * 8

14.) is provided by pressing * 9

For further details see also the communicator's manual.
* 81
* 80
* 91
* 90
e.g. setting/unsetting
9
C.) you can

MKE22102