Safety Testing; Test The Close Cycle; Testing The Open Cycle; Test The Manual Door Operation - featuring Controll-A-Door SDO-2V3 Tri-Tran+ Homeowner's Manual

7. Safety Testing

7.1 Test the Close Cycle

a. Press the transmitter to open the door.
b. Place a piece of timber approximately 40mm high on
the floor directly under the door
c. Press the programmed transmitter to close door.
d. The door should strike the object and re-open.

7.2 Testing the Open Cycle

a. Press the transmitter to close the door
b. Press again to open the door.
c. When the door reaches approximately half way,
firmly grab the door's bottom rail - the door should
stop.
If the door does not reverse readily when closing, or
stop when opening, put the door into manual and
contact your installer immediately for a door service.

7.3 Test the Manual Door Operation

Periodically disengage the opener (Section 6.1) and
manually operate the door. The door must be smooth to
operate by hand. The force required on the bottom rail
should not exceed 15 kg.

7.4 Setting the PET Mode position

When activated, PET mode drives the door to the preset
position from the close position.
a. Drive and stop the door at the desired PET mode
open position by pressing the transmitter button
coded for Open/Stop/Close operation.
b. Press and hold the OPEN button on the opener for
six (6) seconds until the OPEN and CLOSE LED's are
lit to record the new PET position.
To program a transmitter button to operate PET mode
refer to 8.5 Setting PET Mode.
Periodically test if a PET mode button is pressed, while
the door is moving, the door will stop or when the door is
in the PET position, the door will close.
®
Controll-A-Door Prodigy SDO-2V3 Tri-Tran+
(Fig 7.1)
(Fig 7.2).
(Fig.
CAUTION: Take care when
completing a safety test. Failure
to follow this warning can result
in serious personal injury and/or
property damage.
WARNING! If the door is closing
7.1).
and is unable to re-open when
obstructed, discontinue use.
Do not use a door with faulty
obstruction sensing. Contact
your dealer for support.
If transmitter is not programmed,
Refer to Section 8 to program
transmitter.
Fig. 7.1
Fig. 7.2
Diamond PD Power Drive : Instruction
© Copyright 2014 B&D Doors
TM Home Owner's Manual
Select the button on
the transmitter that has
been programmed to
operate the door.
40mm
Manual
9