Enabling Aux Output; Setting Pet (Pedestrian) Mode; To Erase Programmed Codes; Installation Of The Wall Mounted Transmitter - featuring Controll-A-Door SDO-2V3 Tri-Tran+ Homeowner's Manual

8. Coding Transmitters

8.4 Enabling AUX Output

a. Press the CODE SET button four (4) times - the CODE SET LED will illuminate and the courtesy light
will flash quickly.
b. Press one of the four (4) buttons on the transmitter for two (2) seconds, the CODE SET LED will begin
to flash, pause for two (2) seconds, then press the same button again for two (2) seconds. The CODE
SET LED will illuminate for one second then go out.
c. Press the transmitter button to test.

8.5 Setting PET (Pedestrian) Mode

The PET mode position is set during installation.
a. Press the CODE SET button five (5) times - the CODE SET LED will illuminate and the courtesy light
will flash quicky (twice per second).
b. Press one of the four (4) buttons on the transmitter for two (2) seconds, the CODE SET LED will begin
to flash, pause for two (2) seconds, then press the same button again for two (2) seconds.
c. The CODE SET LED will illuminate for one second and then go out, and the courtesy light will also
switch off. This indicates the code has been stored.
d. Press the transmitter button to test.

8.6 To Erase Programmed Codes

If the CODE SET button is pressed and held for six (6)
seconds the CODE SET LED will blink rapidly for one
second to indicate that all programmed codes have
been erased.
8.7 Installation of the Wall Mounted
Transmitter
a. Mount the transmitter in a convenient location, yet
out of reach of children and at least 1.5m off the
(Fig. 8.2).
ground
b. Make sure the door is visible from this location.
c. To set the transmitter codes refer to 8.1.
8.8

Remotely Coding Transmitters

Using this method transmitters can be coded without
access to the opener's control panel as long as a
pre-coded transmitter is available.
a. Take any pre-coded transmitter. Press the button
for the function to be duplicated and release.
b. Using a small needle / pen, press and hold firmly
for two seconds the middle button, through the
(Fig.
Coding Hole
c. Within ten (10) seconds take the additional
transmitter you wish to code.
transmitter's button for two seconds, pause for
two seconds, hold again for two seconds and then
release.
d. Wait for ten (10) seconds and then press the new
transmitter's button to test.
®
Controll-A-Door Prodigy SDO-2V3 Tri-Tran+
8.3).
Hold the new
TM Home Owner's Manual
Fig. 8.2
Fig. 8.3
Diamond PD Power Drive : Instruction
© Copyright 2014 B&D Doors
11
Manual