Coding Transmitters; Storing The Transmitter Code; Setting The Transmitter To Operate The Courtesy Light; Setting Vacation Mode - featuring Controll-A-Door SDO-2V3 Tri-Tran+ Homeowner's Manual

Hide thumbs

Table Of Contents

Table of Contents

Controll-A-Door

8. Coding Transmitters

8.1 Storing the Transmitter Code

The opener can only operate from transmitters that

have been programmed into its receiver. The receiver

needs to learn the codes of any transmitter that will be

used with the operator. Up to sixty four (64) codes can

be stored in the receiver's memory.

a. Press the CODE SET button and release. The

CODE SET LED will illuminate to indicate the

opener is in Code Learn mode. If a valid code is

not stored within 15 seconds the opener will exit

Code Learn

(Fig.

8.1).

b. Press the transmitter button (one of four) that you

want to control the door. The CODE SET LED will

begin to flash.

c. Press the same transmitter button again.

CODE SET LED will illuminate for one second and

then go out.

d. The transmitter is now coded to operate the door -

press the button to test.

8.2 Setting the Transmitter to Operate the

Courtesy Light

Although the courtesy light comes on with each

operation of the opener, it may also be controlled by a

transmitter without operating the door.

a. Press the CODE SET button twice. The CODE

SET LED will illuminate and the courtesy light will

turn on to indicate that the light code learning is

active.

b. Choose a transmitter button not already coded

into the receiver. Press this button and the CODE

SET LED will begin to flash.

c. Press the same transmitter button again. The

CODE SET LED will illuminate for one second and

then go out.

d. The transmitter is now coded to operate the light.

Press the button to test.

8.3 Setting the Transmitter to Operate

Vacation Mode

The opener can be programmed into a "Vacation

Mode" where the opener will not respond to any

transmitter except one preprogrammed unit.

a. Press CODE SET button three times. The CODE

SET LED will illuminate and the courtesy light will

flash slowly (once every two seconds) to indicate

Vacation learning mode is active.

Prodigy SDO-2V3 Tri-Tran+

Home Owner's Manual

ELECTROCUTION! The button

cover is the only cover that should

be removed. All other covers must

remain in place.

CAUTION: Be careful not to press

the operate button while removing

the button cover as the door will

start to move.

IMPORTANT NOTE: Only Tri-Tran+

Technology Transmitters are compatible

with this SDO-2V3 product.

The

Fig. 8.1

b. Choose a transmitter button not already

coded into the receiver. Press this button and

the CODE SET LED will begin to flash.

c. Press the same transmitter button again. The

CODE SET LED will illuminate for one second

and then go out, and the courtesy light will

also switch off. This indicates the code has

been stored.

d. To activate Vacation Mode, close the garage

door and press the coded button transmitter

for 5 seconds. The CODE SET LED will

illuminate to indicate that the opener is in

Vacation Mode.

e. To exit Vacation Mode press the transmitter

button momentarily until the CODE SET LED

turns off.

™

Press

CODE SET

button once

Select one of the

four buttons you

wish to use to

control the door

Table of Contents