Fan Speed Control Dial; Temperature Control Dial; Airflow Control Dial - Subaru 2014 Impreza WRX Owner's Manual

Fan speed control dial

The fan operates only with the ignition
switch in the ON position. The fan speed
control dial is used to select the AUTO
(automatic control) mode or to select the
desired fan speed. The dial s positions
and their functions are as follows.
OFF: The fan does not operate. When the
AUTO mode is operating, the setting of air
inlet is fixed in the OFF position (outside
air). When the AUTO mode is not operat-
ing, the setting will remain in the condition
set just before the air conditioner turned
off.
AUTO: The fan speed is adjusted auto-
matically in accordance with the air
temperature inside and outside the pas-
senger compartment, the intensity of sun-
light, and other factors. SUBARU recom-
mends using the AUTO position.
Other positions: The fan speed can be
adjusted in 7 steps.
NOTE
With the fan speed control dial in the
AUTO position and the airflow control
dial in the , , or
the fan does not operate during engine
warm-up until the engine coolant tem-
perature exceeds approximately 1228F
(508C).

Temperature control dial

This dial is used to set the desired interior
temperature. With the dial set to your
desired temperature, the system automa-
tically adjusts the temperature of air
supplied from the outlets such that the
Climate control/Automatic climate control system
desired temperature is achieved and
maintained.
If the dial is turned fully counterclockwise,
the system gives maximum cooling per-
formance. If the dial is turned fully clock-
wise, the system gives maximum heating
performance.
position,

Airflow control dial

Each dial position activates the following
air outlets.
AUTO: The airflow control is adjusted
automatically in accordance with the air
temperature inside and outside the pas-
senger compartment, the intensity of sun-
light, and other factors. SUBARU recom-
mends using the AUTO position.
(Ventilation): Instrument panel outlets
4-9
CONTINUED