Advertisement
The Receiver
1
1. IMPULSE
Output for timing Impulse (Start gate, photocell – working / closing contact). Respect the polarities.
2. DATA
Female Sub-D 9 : RS232 Output
3. POWER
To switch on the receiver (press for 3 seconds on POWER). The green LED is on. To switch off the
receiver, hold down SET and press POWER.
4. SET
To program the TEAM (A, B, C, D) and to switch off the receiver. Hold down SET during the changes.
5. TEAM
To check the programmed TEAM. The green LED corresponding to the code A, B, C or D is on. To change
the code, hold down SET and press TEAM.
6. LED
LED control panel which shows the programmed TEAM or CHANNEL. Also shows the Received Impulse.
7. LED
Shows the transmission mode :
8. LED
LED control panel which shows the Receiving Level and/or possible interferences created by other radio
signals.
9. BUZZER
To enable or disable the Buzzer
10. TEST BATT
To check the Battery status. The Level will be displayed with the 4 LED's for 4 seconds:
-
-
-
-
-
6
5
4
4 LED's on
= 80-100%
3 LED's on
= 60-80%
2 LED's on
= 40-60%
1 LED on
= 20-40%
1 LED on
= 0-20% power remaining
9
IMPULSE
or
DATA
7
8
10
3
2
Advertisement
