Advertisement
1. Functions
The Transmitter :
9
6
5
4
11
1.
IMPULSE
2.
DATA
3.
POWER
4.
SET
5.
TEAM
6.
CHANNEL
7.
TEST
8.
TEST BATT
9.
LED
10.
LED
11.
CHARGE
Input for timing Impulse (Start gate, photocell – working / closing contact). Respect the polarities.
Male Sub-D 9: RS232 input for
To switch on the receiver (press for 3 seconds on POWER). The green LED is on.
To switch off the receiver, hold down SET and press POWER.
To program the TEAM (A, B, C, D) and to switch off the receiver. Hold down SET during the changes.
To check the programmed TEAM.
To change the code, hold down SET and press TEAM.
To check the programmed CHANNEL.
To change the CHANNEL, hold down SET and press CHANNEL.
For testing the Impulse transmission only. The reception level will be displayed for 0.2 seconds on the
receiver. You'll also get an Impulse on the programmed output.
To check the state of the battery. Press TEST BATT : The Battery level will be displayed with the 4 LED's
for 2 seconds.
LED control panel which shows the programmed TEAM or CHANNEL. Also shows the transmitted Impulse.
Shows the transmission mode :
Charging status Leds. The red led indicates that the Accu is charging. The charge is completed as soon as
the green LED in on.
10
10
10
10
7
8
3
DATA
transfer
IMPULSE
or
DATA
2
1
Advertisement
