Reinstalling Software - Panasonic CF-74 series Operating Instructions Manual

Reinstalling Software

10 Select the settings.
[2]: Enter the size of operating system partition and press Enter.
You cannot create the hard disk backup area if you select [2].
(The size of data partition will be determined by subtracting the operating system partition size from the
maximum size.)
[3]: Windows will be installed in the first partition.
(The size of the first partition must be 20 GB or more. If smaller, installation will not be possible.)
When the hard disk backup function has been enabled, the confirmation message appears to inform that the
backup function will be disabled, and the backup area and data will be erased. Press Y to proceed. If the
reboot message appears, press R to proceed.
At the confirmation message, press Y.
Reinstallation starts automatically. (It will take approximately 20 minutes.)
Do not interrupt reinstallation, for example by turning off the computer or pressing Ctrl + Alt + Del. Other-
wise reinstallation may become unavailable as Windows may not start up or the data may be corrupted.
11 Remove the Product Recovery DVD-ROM, and then press any key to turn off the com-
puter.
12 Turn on the computer, and press
played.
The Setup Utility starts up.
If the password is requested, enter the Supervisor Password.
13 Press .
F9
At the confirmation message, select [Yes] and then press Enter.
The Setup Utility settings excluding the password(s) will return to the default values.
14 Select the [Exit] menu and then select [Save Current Values], then press
At the confirmation message, select [Yes] and press Enter.
15 Turn the computer off by using the power button.
If additional instructions are included with the computer, be sure to read them. It may be necessary to perform
additional operations during the following procedure.
16 Perform the first-time operation (
17 Start the Setup Utility and change the settings as necessary.
To change the drive letter of hard disk or CD/DVD drive
NOTE
Drive letters can be changed only when two or more partitions have been created on the hard disk drive.
The name of the C: drive cannot be changed.
Change the drive letters before installing applications.
A A A A Click [start] - [Control Panel] - [Performance and Maintenance] - [Administrative Tools], and double-click [Com-
puter Management].
B B B B Click [Disk Management] from [Storage].
C C C C Right-click the hard disk partition or the CD/DVD drive name, and click [Change Drive Letter and Paths...].
D D D D Click [Change...].
E E E E Click [Assign the following drive letter] and the new drive letter, and then click [OK].
At the confirmation message, click [Yes].
22
several times while [Panasonic] boot screen is dis-
F2
page 11).
.
Enter