Loading Tape Supply - LabelTac LT4 Reference Manual

Loading tape supply

1 Open cover by pulling both green cover release tabs straight
towards you.
2
Separate the green media holders so they are wider than
the roll of material you are loading.
locked, unlock them by clicking up the lock switch on the left
holder)
(b)
3
Place the supply roll in between the holders, close them onto
the core, and lock the holders into place by clicking down on
the lock switch on the left media holder.
4
Using the green guide adjustment wheel, adjust the media
guides wider than the width of the material, feed the material
through the guides, and then re-adjust the guides so they fit
up against the material while still allowing free movement.
5
Feed the material through the cutter and out the mouth of the
printer. Push the green cover support to the left to disengage
and close the top cover gently.
14 Using LabelTac Loading tape supply
®
(If media holders are
(a)
(c)