Hinge The Control Surfaces - Pro Built GILES 202 Assembly Instructions Manual

Engine Firewall .
we strongly suggest adding some gussets to the firewall area. Always use Epoxy for engine mount
structures due it's superior strength. Add the 1/2'" triangle balsa stock or similar together with an
extra plywood gusset as shown in the photo below. This will prevent any de-bonding of the
firewall areas.
4.
Hinging is a very simple matter. We recommend that you hinge all the control surfaces in
two steps allowing the glue to dry between steps.
There's an important note about hinging the ailerons at the end of this section.
Before you start gluing anything, test fit each control surface. Aileron to wing, elevator to
stabilizer, rudder to fin/ fuse, with the hinges in place. Make sure the hinges go in the holes
smoothly and that there is ample room for the hinge "knuckle" so there is no large gap
Especially if you are using a Gas engine or not using a soft mount system,

Hinge the control surfaces

8