Warranty Information - Pro Built GILES 202 Assembly Instructions Manual

the horizontal stab. Rudder servo trays are below the elevator servos. Don't cut out the
wrong one, and don't cut out the rudder servo trays until you are sure you will be using
tail-mounted servos. Slots for pull-pull cables are located below the rudder servo trays.
Whichever aileron configuration you choose, cover the remaining unused servo tray(s)
with Ultra coat. Throttle servo installation is up to you.
8. There are two drilled holes in the landing gear plate under the covering, these should
match up with the rear pair of holes in the landing gear. Drill these holes through the
aluminum bracket and mount with 4mm screws and locknuts. Use the landing gear as a
template and drill the front pair of holes as well and use 4mm screws and locknuts there
as well. Drill the wheel pants through the hole in the LG bracket and install a 4-40 blind
nut. The tail wheel bracket installation should be obvious. Use springs (included) from
the tail wheel tiller
9. The tank mount has room for a 32oz. DuBro tank. Use double sided Velcro bands and a
piece of carpet nonskid material, or double- sided tape to hold the tank in place.
Tates Performance Hobbies guarantees this kit to be free of defects in both material and workmanship at
the time of purchase. This warranty does not cover any components damaged by use or modification. In
no case shall Tates Performance Hobbies liability exceed the original cost of the purchased kit.
Further, Tates Performance Hobbies reserves the right to change or modify this warranty without notice.
In that Tates Performance Hobbies has no control over final assembly or materials used in final assembly,
no liability shall be assumed or accepted for any damage resulting from the use by user of the final user
assembled product. By the act of using the user assembled product, the user accepts all resulting liability.
If the buyer is not prepared to accept the liability associated with the use of this product, the buyer is
advised to return this kit immediately in new and unused condition to the place of purchase.
While this kit has been flight tested to exceed normal use, if the plane will be used for extremely high
stress flying such as racing or extreme aerobatics the modeler is responsible for taking steps to reinforce
the high stress points.
Read through this manual before starting construction. It contains important
warnings and instructions concerning the assembly and use of this model.
Warning. This is not a toy. If not properly controlled it
can cause injury or death and property damage..
for
controlling the tail wheel. See the accompanying photo.

Warranty Information

22