Advertisement
DIRECTIONAL AND PLAYBACK CONTROL BUTTONS
Operation Modes: Live Mode, Live Freeze Mode, Search Mode, Search-Pause Mode,
Navigation Mode, and PTZ Mode.
Search
Start reverse playback of recordings. Press successively to
change the fast reverse speed.
Replay
Start playback of the most recent recording.
Search
Press to Pause or Play in Search mode.
Search
Start playback of recordings. Press successively to change the
fast forward speed.
Navigation
Move up.
PTZ
Move the camera view point up.
Navigation
Move to the right.
PTZ
Move the camera view point to the right.
Search
Play recorded videos. When pressed successively, the search
jumps forward in time by 30 minute increments.
Search-Pause
Step forward one frame.
Navigation
Move down.
PTZ
Move the camera view point down.
Navigation
Move to the left.
PTZ
Move camera's view point to the left.
Search
Play recorded videos in reverse. When pressed successively,
the search jumps back in time by 30 minute increments.
Search-Pause
Step backwards.
FUNCTION BUTTONS
Setup
Open the setup menu.
Search
Open the search menu.
Live
Change the display mode. Display switches in the following order
when the LIVE key is pressed successively:
(Single > 4 > 9 > 16 > Single > 4 > 9 > etc).
PTZ
In live view, press to enter PTZ mode.
Exit
Exit current menu / function.
Record
Start Emergency Recording when viewing live video.
Backup
In live mode, press to open the backup menu.
In the search mode,
• Press once, to set the start time for Backup.
• Press twice, to set the end time for Backup.
• Press three times, to complete Backup.
VIDEO IN
1
2
3
4
5
6
7
8
AUDIO IN
9
10
11
12
13
14
15
16
AUDIO OUT
HDMI MONITOR
SENSOR IN
PTZ
ALARM OUT +
CAUTION
!
D-
G
1
2
G
1
TV OUT
RISK OF ELECRIC SHOCK
DO NOT OPEN
D+
G
3
4
G
1
PTZ
ALARM OUT -
SENSOR IN
PAL
VGA
1
2
ON
SPOT OUT
HDMI
VGA OUT
USB
NTSC
T V-OUT
DC 12V
12V POWER
VGA MONITOR
REMOTE WORKS
TATION
QUICK INSTALLATION
1.
Connect cameras to video inputs, and if using, connect PTZ camera control lines to
RS485 connector.
2.
Connect the main monitor to the HDMI, VGA, or MAIN (BNC) video outputs.
3.
Connect the monitor to SPOT video output. (optional)
4.
Connect sensors to alarm signal inputs. (optional)
5.
Connect alarm devices such as buzzers to alarm signal outputs. (optional)
6.
Connect external controllers to RS485 connector. (optional)
7.
Connect a speaker and microphone to the audio input. (optional)
8.
Connect a network cable to the network port.
9.
Power on all the connected equipment.
10.
Connect the power cord to the recorder.
Advertisement
