Dry Ironing - TEFAL FV 3510 Superglide User Manual

Moistening the linen (Spray)
- When steam or dry ironing,press several times on
the Spray Button to moisten the linen (H) and to
remove stubborn creases.
- Make sure that there is water in the tank before using
this button.
I
Vertical steam ironing (depending on the model)
1. Hang up the garment on a hanger and hold the fabric slightly taut
with one hand.
2. Set the thermostat control on MAX (J).
3. Press the shot of steam button ( ) repeatedly (K), moving the iron
from top to bottom (L).
4. Hold the iron a few centimetres from the fabric to avoid burning
delicate fabrics.
J
Auto-Stop safety feature (depending on the model)
- The electronic system cuts off the electric power and
the Auto-Stop warning light flashes if the iron is left
vertically on its heel for more than 8 minutes, or in a
horizontal position for more than 30 seconds (M).
- To restart the iron, just move it gently until the warning
light stops flashing.
Note:
When the Auto-Stop warning light is on, it is normal for the thermostat light to be off.

Dry ironing

- Set the steam control on DRY (see diagram A).
- Set the temperature.
- You may start ironing when the thermostat light goes out and comes on
again.
STEAM IRONING
Obtaining more steam for removing
wrinkles (depending on the model)
- Press the shot of steam button from time to time (I)
- Wait a few seconds between each shot before
pressing the button again.
K
H
L
M