Setting The Colour Of The Display; Display - Tuner Mode; Manual Program Search; Automatic Program Search - Pro-Ject Audio Systems Receiver Box S Instructions For Use Manual

Setting the colour of the des display
0 0
M3 M6
decreases
0 0
M4 M7
decreases
0 0
M5 M8
decreases
The changes will be shown in the first line of the display. After leaving the set-op menu, the changes will
become valid for the complete display.
0
M 1
loads the factory settings for brightness and colour. To leave the set-up menu press

Display - tuner mode

A B C
87.90
MANUAL
E
D

Manual program search

Press (approx. 3 seconds)
in 50kHz steps. decreases the reception frequency in 50kHz steps. The tuner is correctly adjusted for a stereo
broadcast when
A the largest number of bars are shown (signal strength meter) and
B two loudspeaker symbols are shown (F one loudspeaker symbol shows mono reception)
C the vertical bar is centred in the fine tuning display

Automatic program search

Press (approx. 3 seconds)
upwards, will start it downwards. The maximum signal strength will be adjusted automatically for each
program found.

Program selection from memory

Press (approx. 3 seconds)
next memory position up the list,
program's memory position is shown to the right of MEMORY in the display.
Saving a program in the memory list
The memory of the Pro-Ject Receiver Box S can store up to 99 programs. Tune to the frequency of the program
to be stored. Press twice in rapid succession. The display will show STORE.
position up the list, selects the next memory position down the list. Press once on
at that position. The display shows STORED.
To be able to select a tuning modes (manual program search, automatic program search or
program selection from memory), a antenna has to be conneced.
Saving a program to a particular memory position overwrites any program already stored at that
position. The memory retains its contents through a power off/on cycle.
increases red
increases green
increases blue
A Signal strength meter
B Stereo reception
C Fine tuning meter
D Tuning mode. The rotary selector toggles between the tuning modes
E Tuned frequency
repeatedly until the display shows MANUAL.
repeatedly until the display shows AUTO.
repeatedly until the display shows MEMORY.
selects the program with the next memory position down the list. The
© Audio Trade GmbH · Pro-Ject Receiver Box S · Revision 2012.9.1
F Mono reception
increases the reception frequency
starts the automatic frequency scan
will select the program with the
selects the next memory
0
OK
.
to store the program
5