Remote Control; Volume; Selecting An Input; Selecting The Tuning Mode - Pro-Ject Audio Systems Receiver Box S Instructions For Use Manual

Remote control

INPUT
ON/OFF
CH+
TUNE TUNE
VOL- OK VOL+
M1 CH- M2
M3 M4 M5
M6 M7 M8
Manual program search - the display shows MANUAL
TUNE TUNE
decreases,
Automatic program search - the display shows AUTO
0
CH-
starts the automatic frequency scan downwards,
Program selection from memory - the display shows MEMORY
0 0
M 1 M8
- activate the memory function. Pressing
0 0
CH- CH+
and select -memory function has to be activated- the memory positions 9 - 99.

Saving a program in the memory list

Tune to the frequency to be stored. Press
0
CH+
will select the next memory position up the list,
The memory positions 1 - 8 can be selected directly by pressing
0
OK
Press once again to store the program at that position. The display shows STORED.
Saving a program to a particular memory position overwrites any program already stored at that
position. The memory retains its contents through a power off/on cycle.
To switch on from standby or to standby
0
ON/OFF
short press turns the unit on, long press takes it back into standby.
Powered on, a short press activates and deactivates mute

Volume

_
0 0
+
VOL
VOL
and

Selecting an input

0
INPUT
selects the inputs and tuner mode in turns

Selecting the tuning mode

Pressing (min. 3 seconds)
search (MANUAL), automatic program search (AUTO) and program selection
from memory (MEMORY) in turns.
increases the reception frequency in 50kHz steps.
0
OK
© Audio Trade GmbH · Pro-Ject Receiver Box S · Revision 2012.9.1
adjust the sound volume
0
OK
selects the tuning modes manual program
0
CH+
starts the scan upwards.
0 0
M 1 M8
- access the presets 1 - 8 directly.
twice in rapid succession. The display will show STORE.
0
CH-
selects the next memory position down the list.
0
M 1 M8
-
0
.
3