Installing The Handle - Toro 20955 Operator's Manual

117-1054
Electric-start model only
Setup
Important: Remove and discard the protective
plastic sheet that covers the engine.
1

Installing the Handle

No Parts Required
Procedure
WARNING
Folding or unfolding the handle improperly can
damage the cables, causing an unsafe operating
condition.
• Do not damage the cables when folding or
unfolding the handle.
• If a cable is damaged, contact an Authorized
Service Dealer.
1. Remove the handle knobs from the mower housing
(Figure 3).
Important: Route the cables to the outside of
the handle knobs as you install the handle.
5
Figure 3