Section 2: Setup Guide - Kidde RemoteLync User Manual

Operating Instructions

Section 2: Setup Guide

NOTE: For this monitor to work properly, you must use it in
conjunction with modern UL-approved smoke, CO, combi-
nation, or heat alarms, and you must have an active resi-
dential wi-fi system.
 • Download and install the appropriate app for your mobile
device by visiting www.kidde.com/RemoteLync, and click-
ing on the appropriate link.
 - Additional links and instructions can be found on the
website.
• Open app and create account.
 • Sign into account
 • Select "Connect monitor to Wi-Fi network"
 • Plug monitor into an outlet that is not controlled by a
switch (see location selection from above).
- All three color LEDs will flash and monitor will announce
"setup starting".
 - For iOS devices, exit app and go to settings>Wi-Fi.
 • Select monitor from list of networks, It will start with
Kidde- followed by several letters and numbers
-For iOS devices, You will then be returned to the app to
select your home network, select continue.
• Enter the passcode for your network and press connect.
• Tap "OK" on the app
• Press the setup button on the monitor after
instruction plays on monitor.
• Select "Enroll my monitor" on app
 • Note: If an error occurs at this point, verify device is
!
on same network.
 • Once registration is complete, test the alarm furthest from
your RemoteLync as instructed by the monitor. Please note
that when you put your alarm into test mode that it will
sound, this is normal – do not remove batteries or cover
unit during this test.
CAUTION: Due to the loudness (85 decibels) of smoke,
!
CO, and heat alarms, always stand an arm's length away
from alarms when testing.
 • Monitor will announce when a smoke or carbon monoxide
alarm is detected.
5