Lan - D-Link DIR-300 User Manual

DIR-300 Wireless N 150 Home Router
User Manual

LAN

To configure the router's local interface, proceed to the Net / LAN page.
If needed, edit the basic settings of the local interface.
Parameter
IP Address
Netmask
When needed settings are configured, click the Save button.
In the DHCP server section, you can configure the built-in DHCP server of the router.
Parameter
Mode
Figure 84. Basic settings of the local interface.
The IP address of the router in the local subnet. By default, the
following value is specified: 192.168.0.1.
The mask of the local subnet. By default, the following value is
specified: 255.255.255.0.
Figure 85. The section for configuring the DHCP server.
An operating mode of the router's DHCP server.
Enable: the router assigns IP addresses to clients automatically in
accordance with the specified parameters. When this value is
selected, the DNS Relay, Start IP, End IP, and the Lease time
fields are displayed on the page.
Disable: the router's DHCP server is disabled, clients' IP addresses
are assigned manually.
Relay: an external DHCP server is used to assign IP addresses to
clients. When this value is selected, the External DHCP server IP
field is displayed on the page.
Page 106 of 170
Configuring via Web-based Interface
Description
Description