Miter Angle; Right 45; Left; Position In - Makita LS1216 Instruction Manual

2
1
3
009522
Fig. B: At right 45° miter angle
Fig. C: At left 45° miter angle
Position crown molding with its WALL CONTACT
EDGE against the guide fence and its CEILING
CONTACT EDGE against the crown molding
stoppers as shown in the figure. Adjust the crown
molding stoppers according to the size of the
crown molding. Tighten the screws to secure the
crown molding stoppers. Refer to the table (C) for
the miter angle.
1
009520

Position in

Miter angle

Fig. A
(1) Right 45°

For inside

corner
(2)
Left 45°
(3)

For outside

corner
(4) Right 45°
006365
7. Cutting aluminum extrusion
009523
When securing aluminum extrusions, use spacer
blocks or pieces of scrap as shown in the figure to
prevent deformation of the aluminum. Use a
cutting lubricant when cutting the aluminum
1. Crown molding
stopper L
2. Crown molding
stopper R
3. Turn base

1. Guide fence

2. Crown molding
2
Table (C)
Finished piece
Save the right side of blade
Save the left side of blade
Save the right side of blade
Save the left side of blade
1. Guide fence
1
2. Vise
2
3. Spacer block
4. Aluminum
3
extrusion
4
5 5. Spacer block
extrusion to prevent build-up of the aluminum
material on the blade.
WARNING:
Never attempt to cut thick or round aluminum
•
extrusions. Thick or round aluminum extrusions
can be difficult to secure and may work loose
during the cutting operation which may result in
loss of control and serious personal injury.
8. Wood facing
Use of wood facing helps to assure splinter-free
cuts in workpieces. Attach a wood facing to the
guide fence using the holes in the guide fence and
6 mm screws.
See the figure concerning the dimensions for a
suggested wood facing.
Over
15mm
Over 290mm
1 135mm 106mm
1. Hole
010046
CAUTION:
Use straight wood of even thickness as the wood
•
facing.
In order to completely cut through workpieces with
•
a height of 102 mm to 120mm a wood facing
should be used on the guide fence. The wood
facing will space the workpiece away from the
fence allowing the blade to complete a deeper cut.
Example:
When cutting workpieces 115 mm and 120
mm high, use a wood facing with the
following thickness.
Miter angle
0°
Left and Right 45°
Left and Right 52°
Right 60°
010048
WARNING:
Use screws to attach the wood facing to the
•
guide fence. The screws should be installed
so that the screw heads are below the surface
of the wood facing so that they will not
21
Over 340mm
116mm 180mm
1
Thickness of wood facing
115 mm 120 mm
35 mm
60 mm
30 mm 45 mm
35 mm
25 mm
25 mm 35 mm