Pioneer CDX-M1026ZG Service Manual page 42

CDX-M1026ZG
- Removing the Pickup Unit(Fig.8)
1.Attach the Short Pin onto the Flexible PCB of the Pickup
Unit.(Fig.8)
2.Remove the Flexible PCB from the connector.(Fig.8)
3.Remove the Torsion Spring which is pressed against the
leading edge of the Feed Screw.(Fig.9)
4 Remove the Screw and Pulley Cover.(Fig.9)
5.Remove the Belt and the Pickup Unit with the Feed Screw
still attached.(Fig.9)
6.Lift the Tabs of the rack section of Holder and remove the
Feed Screw. While doing so, be careful not to lose the
Bearings on the ends of the Feed Screw.(Fig.9)
42
Fig.8
Fig.9