Table of Contents
Advertisement
10. Go to "Completing the FRU replacement.."
Completing the FRU replacement.
After replacing FRUs, you need to install any removed parts, replace the cover, and
reconnect any cables, including telephone lines and power cords. Also, depending
on the FRU that is replaced, you might need to confirm the updated information in
the Setup Utility program.
Note: When the power cord is first plugged in, the computer might appear to turn
1. Ensure that all components have been reassembled correctly and that no tools
2. Make sure the cables are correctly routed and are retained by the cable clips.
3. Lower the drive bay assembly.
4. Close the cover.
5. If your computer is being placed in the vertical position, attach the floor stand.
6. Reconnect the external cables and power cords to the computer. See "Locating
7. If you have replaced the system board, you must update (flash) the BIOS. See
8. Some FRU replacements rquire the configuration to be updated. See Chapter 6,
104
Hardware Maintenance Manual
on for a few seconds and then turn off. This is a normal sequence to enable
the computer to initialize.
or loose screws are left inside your computer.
Attention: To prevent overheating and possible component damage, always
attach the floor stand when placing the computer in the vertical position.
connectors on the front" on page 89 and "Locating the connectors on the rear"
on page 90.
"Flash update procedures" on page 150.
"Using the Setup Utility," on page 53.
Advertisement
Table of Contents
