Lenovo ThinkCentre 7244 Hardware Maintenance Manual page 69

Diagnostic Error Code
071-199-XXX Audio port test failed, cause unknown
071-25X-XXX Audio port failure
080-000-XXX Game Port interface Test Passed
080-XXX-XXX Game Port interface Error
080-195-XXX Game Port interface Test aborted by user
080-196-XXX Game Port interface test halt, error
threshold exceeded
080-197-XXX Game Port interface test warning
080-198-XXX Game Port interface test aborted
080-199-XXX Game Port interface test failed, cause
unknown
086-000-XXX Mouse Port interface Test Passed
086-001-XXX Mouse Port interface Presence
086-032-XXX Mouse Port interface Device controller
failure
086-035-XXX Mouse Port interface Reset
086-040-XXX Mouse Port interface IRQ failure
086-195-XXX Mouse Port interface Test aborted by user
086-196-XXX Mouse Port interface test halt, error
threshold exceeded
FRU/Action
1. See "Undetermined problems" on page 69
2. Flash the system and re-test. See "Updating
(flashing) BIOS from a disc" on page 560
3. Replace component under function test
1. Speakers
2. Audio card, if installed
3. System board
No action
1. Remove the game port device and re-test the
system
Information only Re-start the test, if necessary
1. Press F3 to review the log file
2. Re-start the test to reset the log file
1. Make sure the component that is called out is
connected and/or enabled. See Chapter 6 "Using
the Setup Utility" on page 43
2. Re-run test
3. Replace the component that is called out in warning
statement
4. Replace the component under test
1. If a component is called out, make sure it is
connected and/or enabled. See Chapter 6 "Using
the Setup Utility" on page 43
2. Flash the system and re-test. See "Updating
(flashing) BIOS from a disc" on page 560
3. Go to "Undetermined problems" on page 69
1. See "Undetermined problems" on page 69
2. Flash the system and re-test. See "Updating
(flashing) BIOS from a disc" on page 560
3. Replace component under function test
No action
1. Mouse
2. System board
1. Mouse
2. System board
1. Mouse
2. System board
1. Run Setup
2. Mouse
3. System board
Information only Re-start the test, if necessary
1. Press F3 to review the log file
2. Re-start the test to reset the log file
Chapter 7
.
Symptom-to-FRU index
61