Kenwood KDC-135 Service Manual page 12

KDC-135/135CR/136
Audio-related test mode
Procedure
Press the [AUD] key (main unit)
Press the [AUD] and [∗] keys (Remote control)
About audio adjustment items (include both Audio Function Mode and Audio Setup Mode)
Procedure Item
For item Fader
forwarding Balance
procedure, Bass Level
press [AUD] Middle Level
key and Treble Level
[FM] key LPF Sub
woofer
Volume
Offset
Procedure
Press the [B.BOOST] key for 1 second or longer
MENU-related test mode
Press the [B.BOOST] key (main unit)
Press the [DNPP/SBF] and [DIRECT] keys (Remote control)
Backup current measurement
While ACC OFF (Back Up ON), Reset
PREOUT switching
In the STANDBY source, press and hold [AUTO] key for
1 second or longer
LCD (ED1) short check
In the STANDBY source, press [ATT] key
12
Enter audio adjustment mode (the initial item should be Fader, and then, Balance →
Bass Level → Middle Level → Treble Level → SW Level → System Q → V-Offset →
LPF Sub Woofer.
Procedure
[VOL] knob and [ /
[VOL] knob and [ /
[VOL] knob and [ /
[VOL] knob and [ /
[VOL] knob and [ /
[VOL] knob and [ /
[VOL] knob and [ /
Switch Bass Boost (Note: Front key functions as MENU.)
Procedure
Procedure
Procedure
Procedure
TEST MODE
Adjust to 3 steps of R15 ↔ 0 ↔ F15. (Default value: 0)
] key
Adjust to 3 steps of L15 ↔ 0 ↔ R15. (Default value: 0)
] key
Adjust to 3 steps of -8 ↔ 0 ↔ +8. (Default value 0)
] key
Adjust to 3 steps of -8 ↔ 0 ↔ +8. (Default value 0)
] key
Adjust to 3 steps of -8 ↔ 0 ↔ +8. (Default value 0)
] key
Adjust to 2 steps of 80Hz ↔ Through. (Default value: Through)
] key
(Only in models with Sub Woofer output)
Adjust to 2 steps of -8 ↔ 0. (Default value 0) (Other than model with internal AUX)
] key
Adjust to 3 steps of -8 ↔ 0 ↔ +8. (Default value 0)
(Only models with internal AUX)
Continuous forwarding by remote control is prohibited
MUTE terminal is OFF after 2 seconds, not after 15 seconds.
(During this time, the CD mechanism does not function.)
Switches PREOUT
All lights are off → Turns on odd and even terminals alternatively every
125ms (terminals that have a maximum number of grids) → Turns on only
the odd terminals → Turn on only the even terminals →
Note
Description
Note
Note
Note
Note
Note