Operation (Viewing The Monitor Lamps) - Mitsubishi Electric MA-EF503HS-U Instruction Manual

Operation
On the main unit
Press the power button on the main unit to turn on the
air purifier.
HOUR MIN LOW MED HIGH MAX
TIMER FAN
ON
beep, beep
Each time you press this button, the unit turns ON
or OFF.
Both the operation mode lamp and the monitor
lamp must be ON.
When you plug in the power cord, the monitor
lamps blink for approximately two minutes while
the sensors stabilize.
ODOR
Viewing the monitor lamps
The lamps light up (four levels) depending on amount of air contaminants or odors present.
FAN SPEED
MAX
MIN
POLLEN
GUARD NORMAL
POWER
ON/OFF
AUTO
OFF
beep, beeep
POWER
ON/OFF
Press
MICRO
DUST POLLEN
Clean air
Using the remote controller
Press the power button on the remote controller
to turn on the air purifier. The operation is the
same as on the main unit.
POWER
POWER
AUTO FAN
PLASMA TIMER
How to use the remote controller
The remote controller allows you to operate the unit
from a remote place.
Aim the remote controller toward the main unit
and press the switch. The maximum range of
operation is 23 feet (7 m).
Remote controller
Do not cover the remote
sensor with cloths, etc.
If the main unit does not respond properly to the
signals from the remote controller, replace with
the new batteries.
Make sure the remote sensor and the remote
controller are in sight of one another.
Remote controller operation may not be possible in
the following situations:
In areas where the unit is subjected to direct sunlight.
The infrared rays of the sunlight may effect the remote
sensor on the unit
In rooms with inverter lighting for lower power consumption.
The noise from the inverter lighting may effect the remote
sensor on the unit.
Dirty air
Press
Remote sensor
9