Table of Contents
Advertisement
Preparation
Setting the filters
Remove the plastics from the HEPA filter and the
activated charcoal filter before use.
Press the grill-release buttons, and
1
then remove the intake grill.
Both sides
2
Remove the HEPA filter.
Remove
the plastic
3
Remove the Plasma unit.
Hold the spring
clips, and remove
one side at a time.
4
Install the activated charcoal filter.
5
Replace the Plasma unit, the HEPA
filter, and the intake grill.
8
Hold with both
hands, and pull
to remove.
Remove the
plastic before
installing.
(White particles within the activated
charcoal filter are titanium oxide, not
mildew.)
Installing the batteries for
the remote controller
1
While pushing the cover, slide it
forward.
2
Insert the batteries.
3
Close the cover by sliding it backward
until it snaps shut.
Caution
Use dry cell batteries in a proper manner.
Do not use rechargeable batteries.
Make sure that the positive and negative poles
are correctly aligned.
When replacing, always replace with two new
batteries of the same type.
Should your skin come in contact with the
electrolyte of the alkaline dry cell batteries,
wash the affected area with water. Should the
electrolyte enter your eye, immediately contact
a doctor.
Wrong use may cause injury or malfunction.
12~13
Two AA type batteries
Ensure that the proper polarity is observed.
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the MA-EF503HS-U and is the answer not in the manual?
Questions and answers
Haw can I get a new Filter
To get a new filter for the Mitsubishi Electric MA-EF503HS-U, order the replacement filter set (HEPA filter/activated charcoal filter) with model number MAPR-E837HFT. You can contact your dealer of purchase or Mitsubishi Electric.
This answer is automatically generated