How To Set Controls For Stick Welding - Lincoln Electric SAE-300 HE Operator's Manual

B-3
HOW TO SET CONTROLS FOR STICK
WELDING
1. Set the Right Dial (Fine Current and OCV) to 60.
2. Set the Left Dial (Coarse Current) to the Desired
Current. Make a small increase in current when the
weather warms up.
3. Use Right Dial (Fine Current and OCV) to Make
Changes to the Arc Characteristics and Small
Changes to the Output.
OPERATION
K924-4
Remote Control unit can also be
used as the Right Dial (Fine
Control and OCV).
STICK / TIG WELDING
Start by setting the right-side Fine Current and OCV control
dial to 60, then set the left-side Coarse Current control dial
to the desired current using the dial markings as an approxi-
mate guideline. Arc characteristics and small changes in
output can then be adjusted using the Fine Current and
OCV control dial. A K924-4 Remote Control unit can also be
used as the Fine Control and OCV control dial.
SELF-SHIELDED FLUx-CORED WELDING
(WITH A K3964-1 WIRE FEED MODULE INSTALLED)
Start by setting the Wire (CV) / Stick (CC) toggle switch to
the Wire (CV) position. Then set the left-side Coarse
Current control dial to 270. Now move the Voltage
Adjustment dial to the desired voltage. Move the Coarse
Current control to the left for a softer arc and to the right for
a crisper arc.
®
SAE-300 HE
B-3