Battery Charging - Lincoln Electric SAE-300 HE Operator's Manual

A-6

BATTERY CHARGING

WARNING
GASES FROM BATTERY can explode.
• Keep sparks, flame and cigarettes
away.
BATTERY ACID can burn eyes and
skin.
• Wear gloves and eye protection and
be careful when boosting, charging
or working near battery.
To prevent ExPLOSION when:
a) Installing a new battery - disconnect thenega-
tive cable from the old battery first and connect
the negative cable to the new battery last.
b) Connecting a battery charger - remove the bat-
tery from the welder by disconnecting the nega-
tive cable first, then the positive cable and bat-
tery clamp. When reinstalling, connect the neg-
ative cable last.
c) Using a booster - connect the positive lead to
the battery first, then connect the negative lead
to the ground lead on the base.
To prevent ELECTRICAL DAMAGE when:
a) Installing a new battery.
b) Using a booster.
Use correct polarity - Negative Ground.
To prevent BATTERY DISCHARGE, if you have an
ignition switch, turn it off when engine is not r u n -
ning.
• To prevent BATTERY BUCKLING, tighten nuts on
battery clamp until snug.
------------------------------------------------------------------------
®
The SAE-300 HE is equipped with a wet charged
battery. The charging current is automatically regulat-
ed when the battery is low (after starting the engine)
to a trickle current when the battery is fully charged.
When replacing, jumping or otherwise connecting the
battery to the battery cables, the proper polarity must
be observed. This system is NEGATIVE GROUND.
INSTALLATION
®
SAE-300 HE
A-6