Assembly; Derailleur Geared Bicycles; Getting Started; Handlebars - Infinity MOUNTAIN BICYCLE Owner's Manual

Assembly

3

DERAILLEUR GEARED BICYCLES

Includes 20", 24", 26", 27.5, 29" Wheel Mountain
Bikes Assembly is the same for men and women's
bikes.
Handlebar Binder Bolt
Stem Wedge Bolt
3
Top Nut
Minimum Insertion
Mark
Wedge
Head Tube
24

Getting Started

Open the carton from the top and remove the bicycle. Remove the straps
and protective wrapping from the bicycle. Inspect the bicycle and all
accessories and parts for possible shortages. It is recommended that the
threads and all moving parts in the parts package be lubricated prior to
installation. Do not discard packing materials until assembly is complete
to insure that no required parts are accidentally discarded. Assemble your
bicycle following the steps that pertain to your model. NOTE: Your bicycle
may be equipped with different style components than the ones illustrated.

Handlebars

Remove the protective cap from the handlebar stem wedge and loosen
the Allen key bolt using the 6mm Allen key. Some models may use a
13mm hexagonal bolt instead of an Allen key bolt. Place the handlebar
stem into the top of the head tube, ensuring that all cables are free of
tangles. Tighten the stem bolt observing the minimum insertion mark and
checking that the forks and the handlebars are facing forward. Check the
headset for smooth rotation and the top nut is secured tightly. Loosen the
6mm Binder Bolt and rotate the handlebar. Retighten the Binder Bolt to
ensure the handlebar does not rotate in the stem. NOTE: Some bicycles
may be equipped with a stem that has an adjustable angle. In addition
to the normal assembly, these stems will require angling the stem to the
desired position, and securely tightening the 6mm angle bolt located in
the front of the stem bolt. Failure to do this may cause loss of steering
control.
Warning: Over-tightening the stem bolt or the headset
assembly may cause damage to the bicycle and/or injury
to the rider.
The stem must be inserted so that the minimum insertion
mark cannot be seen.
Bar end (5mm Allen key)
1.
Tighten all bolts that clamp the shifters, brakes levers, and bar end to the handlebar
using a 5mm Allen key or Philips head screwdriver.
(Figure 1) Handlebar with Grip Shifter.
(Figure 2) Top mounted thumb shifter.
Failure to properly tighten clamping bolts may cause sudden
movement of the component resulting in loss of steering control.
Assembly
3
Shifter binder bolt
(2.5 Allen key)
Brake lever binder bolt
(5mm Allen key)
3
Shift binder
bolt (Phillips
head or 5mm
Allen key)
2.
25