Install Wired Door Controls - Chamberlain 5410E 2013 Owner's Manual

Install Wired Door Controls (optional accessory)
Locate wired door controls where the garage door is visible, away
from door and door hardware, out of the reach of children and at a
height of at least 1.5 m.
SERIOUS PERSONAL INJURY FROM A MOVING GARAGE DOOR
MAY RESULT FROM MISUSE OF OPENER. DO NOT ALLOW
CHILDREN TO OPERATE THE WIRED DOOR CONTROLS OR
REMOTE CONTROLS.
FASTEN THE CAUTION LABEL ON THE WALL NEAR WIRED
DOOR CONTROLS AS A REMINDER OF SAFE OPERATING
PROCEDURES.
There are 2 screw terminals on the back of the wired door
controls. Strip about 11 mm (7/16") of insulation from bell wire.
Separate wires enough to connect the white/red wire to terminal
screw 1 and the white wire to terminal screw 2.
Fasten wired door controls to an inside garage wall with 6ABx1-
1/2" sheet metal screws provided. Drill 4 mm (5/32") holes and
use anchors if installing into plaster wall. A convenient place is
beside the service door and out of reach of children.
Run the bell wire up the wall and across the ceiling to the garage
door opener. Use insulated staples to secure wire. Connect the
bell wire to the spring terminals (located on the back panel) as
follows: white/red to 1 and white to 2.
Push Button Cover
EXTERNAL RECEIVERS
Where a secondary receiver is required to trigger your opener,
power may be obtained from the 24 VDC output terminals
located on the back of your 5410E.
1. Use the grey 24 VDC + (max 100 mA) terminal and the white
terminal.
2. Run a bell wire from the COM and NO output of the receiver into
the red and white terminals located above the RED learn button.
Bell Wire
Bell Wire
Door
Control
Screw
Terminals
OPERATION OF THE WIRED DOOR CONTROLS
Press to open or close the door. Press again to reverse the door
during the closing cycle or to stop the door during opening cycle.
Screw 6ABx1-1/2"
Lighted Door Control Button
Screw
6ABx1-1/2"
Lighted Door
Control Button
Door
Control
31
HARDWARE SHOWN ACTUAL SIZE
Drywall
Anchors
Door Control Connections
7/16"
(11 mm)
Strip wire 7/16" (11 mm)
Red White
To release or insert wire,
push in tab with screwdriver tip
External Receiver
Insulated
Staples (not
shown)