Summary of Contents for Chamberlain LiftMaster Professional 50-1950
Page 1
Push-to-Open Kit Model 50-1950 1. Assemble post bracket assembly by placing push-to-open bracket 3/8" Hex Bolt Figure 1 between the two post brackets as shown. Insert 3/8" hex bolt through middle hole. Fasten with lock washer, flat washer and nut (Figure 1). 2.
Page 2
Figure 4 7. With gate open and operator in retracted position, clamp bracket to Gate in Open Position cross member, using C clamp. Adjust operator until assembly is level. Tighten in place at this time (Figures 4 & 6). NOTE: All four mounting holes must be used. 8.