Toshiba T2150 series Maintenance Manual page 118

Disassembly Procedures
The T2150 series has two basic types of cable connectors:
Pressure Plate Connectors
Normal Pin Connectors
To disconnect a Pressure Plate connector, lift up the tabs on either side of the connector's
plastic pressure plate and slide the cable out of the connector. To connect the cable to a
Pressure Plate connector, make sure the pressure plate is fully lifted and slide the cable into
the connector. Secure the cable in place by pushing the sides of the pressure plate down so
the plate is flush with the sides of the connector. Gently pull on the cable to make sure the
cable is secure. If you pull out the connector, connect it again making sure the connector's
pressure plate is fully lifted when you insert the cable.
Standard pin connectors are used with all other cables. These connectors can be connected
and disconnected by simply pulling them apart or pushing them together.
Assembly Procedures
After you have disassembled the T2150 series and fixed or repaired the problem that was
causing the T2150 series to operate abnormally, you will need to reassemble the T2150
series.
While assembling the T2150 series, remember the following general points:
Take your time, making sure you follow the instructions closely. Most problems arise
when you hurry to assemble the T2150 series.
Make sure all cables and connectors are securely fastened.
Before securing the FRU or other parts, make sure that no cables will be pinched by
screws or the FRU.
Check that all latches are closed securely in place.
Make sure all the correct screws are used to secure all FRUs. Using the wrong screw
can either damage the threads on the screw or the head of the screw and may prevent
proper seating of an FRU.
After installing an FRU in the T2150 series, confirm that the FRU and the T2150 series are
functioning properly.
T2150 Series
4-3