Panasonic Toughbook CF-27 Series Reference Manual page 6

Suspend/Hibernation Functions
Precautions for Using the Suspend or Hibernation Function
Save all data before powering off your computer.
When restarting from or shutting down to the suspend or hibernation mode, do not
touch the touch pad or touchscreen (or move the mouse (serial or PS/2 type) if one is
connected). These devices may fail to operate, you will then need to restart your
computer using the keyboard.
Do not power off during the following periods (you may corrupt your data or file):
• While the MP indicator (
• While playing/recording audio files.
• While communications software is being used.
Do not use the suspend or hibernation function when using an operating system other
than the one that comes with your computer, the Setup Utility, or when experiencing
static electricity or noise.
If you hold down on the Alt , Ctrl or Shift
hibernation mode, after resuming operation, you must press the same key. For ex-
ample, if you hold down on the
resuming, if you do not press the
typing.
Only when the computer stops operating or locks up should the power switch be held
more than four seconds to power off the computer. Slide the power switch to power on
and data not previously saved will be lost.
In the suspend mode, power is consumed. If PC Cards (e.g., a modem card) are
inserted, more of that power may be consumed. When all power has been consumed,
all data at suspend is lost since it is retained in memory. We therefore recommend
plugging in the AC adapter when using the suspend function.
Repeatedly using the suspend or hibernation function will use up a lot of the system
resources and the computer may not work properly. Shut down Windows ([Start]-
[Shut Down]) on a regular basis, i.e. approximately once a week, without using the
suspend or hibernation function. Doing so will restore the system resources.
Do not use the suspend or hibernation function during the following periods. The
suspend or hibernation function, or peripherals may not work.
• When a file in external devices such as a CD-ROM drive, external hard disk, or ATA
card is opened, the suspend or hibernation function may not work. In such cases,
close the file.
• SCSI cards may not recover after entering the suspend or hibernation mode. If this
occurs, restart the computer.
Confirm that Phoenix APM 2.0 for Windows NT
time to be normally displayed with the suspend or hibernation function. (If [APM 2.0
for NT] is displayed in [Control Panel], this means that the program is installed.)
Do not use the suspend or hibernation function when using in a network environment
or when connecting the port replicator.
If [Suspend Timeout] or [Hibernation Timeout] has been set to [16 min] in the Setup
Utility, the timeout function does not work.
) or HDD indicator ( ) is on.
Shift key while pushing the power switch, upon
key again, only capital letters will result from
Shift
® is installed, in order for the date and
key to enter the suspend or
6