Emptying The Drum; Moving The Wet/Dry Vac; Blowing Feature - Husky HV06000 Operator's Manual

SP6688-2 HUSKY-ES.qxd
3. When the liquid in the drum reaches a
predetermined level, the float
mechanism will rise automatically to cut
off air-flow. You will know that the float
has risen because suction stops and the
motor noise will become higher in pitch,
due to increased motor speed. When this
happens, turn off the vac, unplug the
power cord, and empty the drum.
4. After using the vac to pick up liquids, the
filter must be dried to avoid possible
mildew and damage to the filter.

Emptying the Drum

1. Remove the lid. Pull the flexible latches
outward on each side of the lid to
release from the drum.
2. While holding the latches out, lift the
top assembly up and away from the
drum.
3. Lay top assembly upside down on a
clean area while emptying drum or
changing filter.
4. Dump the drum contents into the
proper waste disposal container.

Moving the Wet/Dry Vac

Should it become necessary to pick the
vac up to move it, DO NOT pick the vac
up by the lid handles unless dust drum is
empty. To avoid dropping the vac, due to
latches releasing or possible part
breakage, pick the vac up by the dust
drum.
7/24/08 9:02 AM
9
Page 9

Blowing Feature

Your Wet/Dry Vac features "Full Blowing".
It can blow sawdust and other debris.
Follow the steps below to use your vac as
a blower.
!
WARNING: Always wear safety
eyewear complying with ANSI Z87.1
(or in Canada, CSA Z94.3) before
using as a blower.
!
WARNING: To reduce the risk of
injury to bystanders, keep them
clear of blowing debris.
!
CAUTION: Wear a dust mask if
blowing creates dust which might
be inhaled.
1. Locate blowing port of your Wet/Dry
Vac.
2. Insert the larger end of hose into the
blowing port of the vac.
3. (Optional) Attach extension wand to
swivel end of hose.
4. Turn vac on and you are ready to use
your vac as a blower.
Hose
Extension
Wand
(optional)
Blowing
Port
Swivel
End of
Hose