Caster/Caster Foot Assembly; Replacement Filter Assembly - Husky HV06000 Operator's Manual

Husky hv06000/ hv09000 6 gallon/22.5 liter and 9 gallon/34.1 liter wet/dry vacs

Hide thumbs

Table of Contents

Available languages

SP6688-2 HUSKY-ES.qxd

1. Turn the dust drum upside down on

the floor.

2. Insert the caster feet into the bottom of

drum, as shown (4 places).

3. Push on the caster foot until the foot is

flush with bottom of the dust drum.

4. Insert the caster stem into the socket

of the caster foot, as shown (4 places).

5. Push on the caster until the ball on the

caster stem is inserted all the way into

the socket. You will hear the ball snap

into the socket and the caster will

swivel easily when positioning is

correct.

6. Turn the drum upright.

1. Carefully slide the filter over the filter

cage, sliding it over the center ring

covering the 3 slots until the filter stops

against the lid.

2. Place filter nut and filter plate onto

threaded stud and tighten it down.

Finger tighten only.

NOTE: Lever of filter nut should be away

from plate as shown.

IMPORTANT: Do not overtighten as this

may deform or crack the filter cage, or

filter.

NOTE: If filter cage or float needs to be

replaced or removed, use a flat blade

screwdriver and insert the blade near one

of the tabs between the filter cage and

the center ring of the lid. Pry the tab out

of the slot. Tilt the cage and lift away from

the lid. To replace, follow the assembly

instructions below:

WARNING: For your own safety,

never connect plug to power source

outlet until all assembly steps are

complete and you have read and

understood the safety and operation

instructions. Do not operate vac

with any parts damaged or missing.

7/24/08

9:02 AM