Wet/Dry Vac Assembly; Insert Hose - Husky HV06000 Operator's Manual

SP6688-2 HUSKY-ES.qxd
Replacement Filter Assembly (continued)
3. Place the float over the opening in the
center of the lid with the words "This
Side Towards Lid" laying face down
over the hole.
4. Line up filter cage tabs with slots in the
center ring of the lid.
5. Push on the filter cage until the tabs
snap into slots for a secure fit.
1. Line up vacuum port above drum
label.
2. Place lid on top of drum with the
handles snug against the drum
channel.
3. Be sure lid completely covers the top
of the drum so leakage does not
occur.
4. Make sure that the locking tabs are
snapped in place to prevent the lid
from coming off (see insert).

Insert Hose

Insert the larger end of the hose into the
vacuum port.
Place the utility nozzle securely on the
opposite end of the hose and the vac is
ready for use.
7/24/08 9:02 AM

Wet/Dry Vac Assembly

6
Page 6
Filter
Cage
Tabs (3)
Float
Solid End
THIS SIDE
TOWARD LID
Drum
Drum
Channel
Vacuum Port
Filter
Cage
Tabs (3)
Slots
(3)
Power
Assembly
Slots (3)
Flexible Locking
Tab Pulled Out
Flexible
Locking Tab
Powerhead
Push Down
and Pull Out
Flexible
Locking Tab
(located
under latch)