Adjusting The Miter Angle; Adjusting The Bevel Angle - Makita LS0815F Instruction Manual

Stopper arm
1
2
010233
The lower limit position of the blade can be easily
adjusted with the stopper arm. To adjust it, move the
stopper arm in the direction of the arrow as shown in the
figure. Adjust the adjusting screw so that the blade
stops at the desired position when lowering the handle
fully.

Adjusting the miter angle

2
1
010234
Loosen the grip by turning counterclockwise. Turn the
turn base while pressing down the lock lever. When you
have moved the grip to the position where the pointer
points to the desired angle on the miter scale, securely
tighten the grip clockwise.
CAUTION:
After changing the miter angle, always secure the
•
turn base by tightening the grip firmly.
NOTICE:
When turning the turn base, be sure to raise the
•
handle fully.

Adjusting the bevel angle

1
014281
1. Stopper arm
2. Adjusting screw
1. Miter scale
2. Pointer
3. Lock lever
4. Grip
3
4
1. Lever
To adjust the bevel angle, loosen the lever at the rear of
the tool counterclockwise. Unlock the arm by pushing
the handle somewhat strongly in the direction that you
intend to tilt the saw blade.
NOTE:
Lever can be adjusted to a different lever angle by
•
removing the screw holding the lever and securing
the lever at a desired angle.
1
2
3
4
014307
Tilt the saw blade until the pointer points to the desired
angle on the bevel scale. Then tighten the lever
clockwise firmly to secure the arm.
1
2
3
014308
To tilt the saw blade to right 5 ﾟ or left 48 ﾟ: set the saw
blade to 0 ﾟ for right 5 ﾟ, or 45 ﾟ for left 48 ﾟ. Then
slightly tilt the saw blade to the opposite side. Push the
release button and tilt the saw blade to the desired
position. Tighten the lever to secure the arm.
CAUTION:
After changing the bevel angle, always secure the
•
arm by tightening the lever clockwise.
NOTICE:
When tilting the saw blade be sure the handle is
•
fully raised.
When changing bevel angles, be sure to position
•
the kerf boards appropriately as explained in the
"Positioning kerf boards" section.
8
1. Lever
2. Arm
3. Pointer
4. Bevel scale
1. Pointer
2. Release button
3. Bevel scale